国产国产人在线成免费视频

    <var id="tbxrt"><ins id="tbxrt"></ins></var>

        <big id="tbxrt"><listing id="tbxrt"></listing></big>
          <span id="tbxrt"><menuitem id="tbxrt"><dfn id="tbxrt"></dfn></menuitem></span>

          Shenzhen Grande Electronic Linkedin Page
          Shenzhen Grande Electronic Co., Ltd logo
          E-mail us for a Quote:
          sales88@greattong.com
          Call us now:
          +86-755-83261869

          Technical Article


          Basic Factors in PCB Design

          Time:2017-03-03 11:51:09 Click:

          Various key factors have to be kept in mind while designing a PCB for a quality design. An important principle of PCB design, which becomes more critical in mixed signal design in order to avoid noisy signals and abnormal functioning is keeping analogue and digital grounds separated. 

           


           

          Since in auto-routing the computer recognizes it as a single ground and routes accordingly, grounds are to be routed manually to avoid it. In addition to this:

          1. For each digital IC, capacitors should be placed between its input power and ground
          2. High frequency tracks should be kept short
          3. Signals with high frequency should have a ground plane below them; they shouldn’t be run over gaps
          4. Analogue circuits and digitals circuits should be kept separated
          5. Analogue ground and digital grounds should be kept separated but connected to a common point
          6. 90o bends in tracks should be avoided, instead 45o bends can be used to avoid noise and signal reflections.
          7. Power and ground tracks should be wide so that they have a higher current limit, also they should be placed first
          8. Auto-routing should be avoided when possible
          9. There shouldn’t be any copper fills unconnected on a PCB. They can be grounded to act as a heat sink or removed.
          10. Vias shouldn’t be placed under the components
          11. Through hole components ca be used as vias since the hole is connected to layers underneath
          12. Drill size for holes and vias should be kept minimum

          Previous:6 Steps for Creating an Electronic Design Schematic

          Next:PCB Fabrication BGA Prototyping Boards


          Request an Official Quote

          Questions

          E-MAIL

          File Upload

          Upload a list of files

            Please upload your Gerber files and BOM. You can upload an unlimited number of files as long as the total size of all files does not exceed 20 MB. To ensure you receive your official quote in less than 24 hours, please include the quantity of circuit boards for which you would like a quote.

            If you require that we sign a Non-Disclosure Agreement (NDA), please send it to us prior to sending your files and we will be happy to accommodate.

             
            Home About Us Services Quality Pb-Free News Contact Us


            Copyright ® 2017,Shenzhen Grande Electronic Co., Ltd. All Rights Reserved. 中文站 Sitemap

            国产国产人在线成免费视频

              <var id="tbxrt"><ins id="tbxrt"></ins></var>

                  <big id="tbxrt"><listing id="tbxrt"></listing></big>
                    <span id="tbxrt"><menuitem id="tbxrt"><dfn id="tbxrt"></dfn></menuitem></span>